Featured Cycles
We are cutting and raking the neck to fit a 26" front wheel. Air ride, extended saddle bags, handle bars, exhaust and much more.
SMC Fabs
OBMF
We cut the neck and raked it 20* and stretched it 2" from stock. 26" front wheel. We redesigned the inner and outer fairing and lowered it 2". Custom fuel tank and dash panel. We made the exhaust, saddle bags, seat, handle bars, fenders, lights, grips and much more. We went completly through the motor, adding a new top end, heads, pistons, cams, oil pump and tensioners. We rebuilt the trans also. 2" open primary, forward controls, internal throttle and air ride front and rear.
"06 Street Glide
The bike came to the shop as a stock wreck. We cut the neck and raked it 8* and still keep the original VIN#. We extended the saddle bags and paint and bodied the bike with a blue true fire paint job. Added a 21" front wheel and an 18" rear and just a little wider than stock.
Grounds For Divorce
Remote Ignition by SMC. The frame built by SAT and SMC. Handle bars, SMC Homicide shifter, oil bag, tank, fender, seat, and controls built and designed by SMC. Grips are built by Xoprodox and designed by SMC. Headlight is HID by SMC. This bike was built for the Big Texas Chop-off of Champions and placed 3rd
CFH
Custom fenders by B’Cool and SMC. Frame was built by DHC and SMC. Handle bars, gas tank, rear sets/shift made by SMC. This bike was built for the Big Texas Chop-Off of Texas and placed 2nd.
Texas Bobber
This is a bobber we are building and will unviel it a ROT 2011. Come see it on the main arena floor in the Thunderdome.
Board Tracker
This is going to be a board tracker prodject with a 88" motor and kick start. 23" wheels front and rear.
Honda VTX 1300r
We cut the neck off, made an American neck, raked and streched the frame to hold a 23" front wheel. We cut the rear end off, molded it and made the swing arm 
for a 240. We made new side panels, streched the fuel tank, removed the seam and shaved the gauges. We also black out the motor and misc. pieces.
"03 Honda VTX1800r
We cut the stock neck off and made our own American neck to run a cleaner front end with a 23" front wheel. It is raked at 50* and streched 2". We have also modified the swing arm to hold a 240 rear tire. We will be making a custom tank, fenders, handle bars and internal throttle and clutch to name a few
Pro Street
2003 FLSTF
We cut the neck and raked it to hold a 23" front wheel. Jumped the rear wheel up to an 18", 200 series. Custom fenders front and rear.
200 Pro Street XL
We are building a 200 pro street xl. We are now in the process of cutting, streching and raking the frame more and adding a radius down tube.
2012 Road Glide
We are cutting and raking the neck to fit a 26" front wheel. Air ride, extended saddle bags, handle bars, exhaust and much more.